Led Oti Dali 15/220-240/1A0 NFC TWI (orange cable clamps included) 4062172211543

Osram

Part No
LEDOTIDALI15NFCTWI
£39.38 £32.82
In stock

OTi DALI 15/220…240/1A0 NFC TW I

EAN: 4052899631625

Product family benefits

Control of standard white or Tunable White light acc. DALI device type 8 (DT8)
TouchDIM Tunable White integrated for use without additional LMS
Fully programmable via T4T software (NFC, DALI Interface)
Lifetime: up to 100,000 h (temperature at Tc = 65 °C, max. 10 % failure rate)
High-quality dimming of 1…100 % by amplitude dimming
High quality of light thanks to <1% output ripple current
Fulfill safety requirement due to overload, overtemperature, Hot Plug protection

Areas of application

Classrooms
Conference rooms
Daylight simulation for windowless rooms
For Tunable White as well as for 2-channel use (e.g. direct/indirect lighting)
Healthcare and hospitality with HCL functionality
Independent mounting via Cable Clamp Kit possible
Installation in emergency lighting systems according to IEC 61347-2-13, appendix J
Office with high end HCL functionality
Suitable for indoor and outdoor SELV installations

Technical Data

Electrical Data
Nominal input voltage: 220…240 V
Mains frequency: 0/50/60 Hz
Input voltage AC: 198…264 V
Input voltage DC: 176…276 V
Total harmonic distortion: < 15 %
Power factor λ: 0.47C...0.92C
Efficiency in full-load: 85 %
Inrush current: 17 A
Max. ECG no. on circuit breaker 10 A (C): -
Max. ECG no. on circuit breaker 10 A (B): 27
Max. ECG no. on circuit breaker 16 A (C): -
Max. ECG no. on circuit breaker 16 A (B): 43
Max. ECG no. on circuit breaker 25 A (B):-
Surge capability (L/N-Ground): 2 kV
Surge capability (L-N): 1 kV
Nominal output voltage: 7.5…54 V
U-OUT (working voltage): 60 V
Nominal output current: 150…1050 mA
Default output current, 2-channel DT6:300 mA
Default output current, TW DT8: 300 mA
Output current tolerance: ±3 %
Output ripple current (100 Hz):< 2 %
Output PSTLM: <1
Output SVM: <0.4
Nominal output power: 18 W
Maximum output power: 18 W
Galvanic isolation DALI/output: SELV
Power loss in stand-by mode:<0.2 W
Galvanic isolation primary/secondary: SELV
Current set: DALI / NFC
Default output current: 300 mA
Networked standby power: <0.20 W
Galvanic isolation DALI/mains: Basic

Dimensions & weight

Mounting hole spacing, length: 167.8 mm
Mounting hole spacing, width: -
Product weight: 190.00 g
Cable cross-section, input side: 0.75…1.5 mm²
Cable cross-section, output side: 0.2…1.5 mm²
Wire preparation length, input side: 8.0…9.0 mm 
Wire preparation length, output side: 8.0…9.0 mm
Width: 44.5 mm
Length: 203.0 mm
Height: 34.0 mm

Colors & materials
Casing material: Plastic

Temperatures & operating conditions
Ambient temperature range: -25…+50 °C
Maximum temperature at tc test point: 75 °C
Max.housing temperature in case of fault: 110 °C
Temperature range at storage: -40…+85 °C
Permitted rel. humidity during operation: 5…85 %

Lifespan
ECG lifetime: 50000 / 100000 h

Additional product data
Encapsulated: No

Capabilities
Dimmable: Yes
Dimming interface: DALI-2 / Touch DIM / Touch DIM Sensor
Dimming range: 1…100 %
Dimming method: Amplitude Modulation
Overheating protection: Automatic reversible
Overload protection: Automatic reversible
Short-circuit protection: Automatic reversible
No-load proof: Yes
Intended for no-load operation: No
Max. cable length to lamp/LED module: 2.0 m
Suitable for fixtures with prot. class: I / II
Type of connection, input side: Push terminal
Type of connection, output side: Push terminal
Detection angle (Light sensor): -
Suitable for through-wiring: Yes
Suitable for emergency lighting: Yes
DALI-2 Diagnostic Data: Yes
DALI-2 Energy Data: Yes
Control interface: DALI-2
Programming interface: DALI, NFC
Number of channels: 2
Detection angle (PIR): -
Constant lumen function: Programmable

Programming
Programming device: DALI / NFC
Tuner4TRONIC: Yes
Box programming: Yes
Tuner4TRONIC Field App: No

Programmable features
Soft Switch Off: Yes
Dim to Dark: Yes
TouchDIM + Sensor: Yes
Emergency Mode: Yes
DALI-2 Luminaire Data: Yes
Configuration Lock: Yes
OEM Key: No
Corridor Functionality: Yes
DALI Settings: Yes
End of Life: -
Driver Guard: Yes
Operating Current: Yes
Constant Lumen: Yes
Lamp Operating Time: Yes

Certificates & standards
Approval marks – approval: CE / UKCA / EAC / DALI-2 / EL
Standards: Acc. to IEC 61347-1/Acc. to IEC 61347-2-13/Acc. to IEC 62384/Acc. to EN 55015/Acc. to IEC 62386/Acc. to IEC 61000-3-2/Acc. to IEC 61000-3-3/Acc. to IEC 61547/Acc. to CISPR 15/Acc. to ETSI EN 300 330/Acc. to ETSI EN 301 489 - 1/Acc. to ETSI EN 301 489-3
Protection class: II
Type of protection: IP20

Logistical data
Commodity code: 850440839000

Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration: 28-04-2023
Primary Article Identifier: 4062172211543
Candidate List Substance 1: Lead
CAS No. of substance 1: 7439-92-1
Safe Use Instruction: The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database: 916838d0-81e1-4a79-b593-f34f3f44c7d1

Technical Information
Weight 190g
Customer Questions
No Questions
Did you find what you were looking for?
Write Your Own Review
You're reviewing:Led Oti Dali 15/220-240/1A0 NFC TWI (orange cable clamps included) 4062172211543
For price, stock availability and other information about this product, please contact us using the form below.

sgm_clp_1 div for segmentify