Led Driver Oti Dali 50/220-240/1A4 Lt2 L G2 4052899551787

Osram

Part No
LEDOTIDALI50A4LT2G2
Led Driver Oti Dali 50/220-240/1A4 Lt2 L G2 4052899551787

EAN: 4052899551787

Product family benefits:
Fully programmable via software (DALI Interface)
Flexible current setting (LEDset2)
Lifetime: up to 100,000 h (temperature at Tc = 65 °C, max. 10 % failure rate)
High-quality dimming of 1…100 % by amplitude dimming (except 80 W versions)
High quality of light thanks to <1% output ripple current
Very high efficiency
Very low standby power consumption: < 0.15 W *
Fulfill safety requirement due to overload, overtemperature, Hot Plug protection

Versatile scope of application due to OSRAM DALI Technology:
Easy to use in corridors and restrooms because of three-level Corridor function
Touch DIM application: easy to control via pushbutton or sensor
Energy efficient Touch DIM operation due to automatic switch-off at sufficient residual light
Suitable for emergency Installations (acc. to EN 60598-2-22 and IEC 61347-2-13, appendix J) thanks to DC detection (0 Hz, pulsating DC), on/off switchable
Feedback of power consumption and operating hours (Fit for SMART GRID)
Suitable for buildings according to EPBD/BREEAM/LEED due to automatic Constant Lumen Output setting
Luminaire information for easy maintenance

Areas of application:
Linear lighting for office, education, storage areas and retail
Installation in emergency lighting systems according to IEC 61347-2-13, appendix J
Suitable for luminaires of protection class I

Electrical data:
Nominal input voltage: 220…240 V
Mains frequency: 0/50/60 Hz
Input voltage AC: 198…264 V
Input voltage DC: 176…276 V
Current set: DALI / LEDset / Programmable
Total harmonic distortion: < 15 %
Power factor λ: > 0.95
Efficiency in full-load: 90 %
Device power loss: 6.0 W
Networked standby power: ≤ 0.17 W
Protective conductor current: <0.5 mA
Inrush current: 20 A
Max. ECG no. on circuit breaker 10 A (B) : 13
Max. ECG no. on circuit breaker 16 A (B) : 20
Max. ECG no. on circuit breaker 25 A (B) : -
Surge capability (L/N-Ground) : 2 kV
Surge capability (L-N) : 1 kV
Nominal output voltage: 15…54 V
U-OUT (working voltage) : < 60 V
Nominal output current: 600…1400 mA
Output current LEDset open: 300 mA
Output current LEDset shorted: 1400 mA
Default output current: 300 mA
Output current tolerance: ±3 %
Output ripple current (100 Hz) : < 1 %
Output PSTLM: ≤1
Output SVM: ≤0.4
Nominal output power: 12…50 W
Maximum output power: 50 W
Galvanic isolation: SELV

Dimensions & weight:
Mounting hole spacing, length: 350.0 mm
Product weight: 240.00 g
Cable cross-section, input side: 0.5…1.5 mm²
Cable cross-section, output side: 0.5…1.5 mm²
Wire preparation length, input side: 8.0…9.0 mm
Wire preparation length, output side: 8.0…9.0 mm
Length: 360.0 mm
Height: 21.0 mm
Width: 30.0 mm

Colors & materials:
Casing material: Metal

Temperatures & operating conditions:
Ambient temperature range: -25…+50 °C
Maximum temperature at tc test point: 75 °C
Max.housing temperature in case of fault: 110 °C
Temperature range at storage: -40…+85 °C
Permitted rel. humidity during operation: 5…85 %

Lifespan:
ECG lifetime: 50000 / 100000 h

Additional product data:
Encapsulated: No
Predecessor EAN: 4052899028098

Capabilities:
Programming interface: DALI, LEDset
Dimmable: Yes
Dimming interface: DALI-2 / Touch DIM / Touch DIM Sensor
Dimming range: 1…100 %
Dimming method: Amplitude Modulation
Constant lumen function: Programmable
Overheating protection: Automatic reversible
Overload protection: Non-reversible
Short-circuit protection: Automatic reversible
No-load proof: Yes
Intended for no-load operation: No
Max. cable length to lamp/LED module: 2.0 m
Suitable for fixtures with prot. class: I
Suitable for emergency lighting: Yes
Type of connection, input side: Push terminal
Type of connection, output side: Push terminal
DALI-2 Diagnostic Data: Yes
Number of channels: 1
Control interface: DALI
DALI-2 Energy Data: Yes

Programming:
Programming device: DALI magic
Tuner4TRONIC: Yes
Tuner4TRONIC Field App: Yes

Programmable features
Operating Current: Yes
Constant Lumen: Yes
Lamp Operating Time: Yes
Driver Guard: Yes
DALI Settings: Yes
Emergency Mode: Yes
DALI-2 Luminaire Data: Yes
Soft Switch Off: Yes
Dim to Dark: Yes
TouchDIM + Sensor: Yes
Corridor Functionality: Yes
OEM Key: Yes

Certificates & standards:
Approval marks – approval: CE / EL / VDE-ENEC / VDE-EMC / EAC / CCC / RCM / BIS
Standards: Acc. to EN 61347-1/Acc. to EN 61347-2-13/Acc. to EN 55015/Acc. to EN 61547/Acc. to EN 61000-3-2/Acc. to EN 62384/Acc. to EN 62386
Type of protection: IP20

Logistical data:
Commodity code: 850440829000
Technical Information
Weight 240g
Customer Questions
No Questions
Did you find what you were looking for?
Write Your Own Review
You're reviewing:Led Driver Oti Dali 50/220-240/1A4 Lt2 L G2 4052899551787
Your Rating
For price, stock availability and other information about this product, please contact us using the form below.
For price, stock availability and other information about this product, please contact us using the form below.

sgm_clp_1 div for segmentify